Nireco International GmbH | Deilbachtal 199, 45257 Essen | +49 (0)201 / 858 946-0 | info@nireco.de

Sensor NIGDuo

Two pairs of eyes see more than one!

The stereoscopic camera sensor – NIGDuo

Full use, whether for edge or strip position measurement

You have little space in the line and changing strip positions and want to determine the strip position with the highest precision? Then our stereoscopic camera sensor NIGDuo is just right for you. It can be used flexibly both as an edge position sensor and as a strip position sensor.

In the NIGDuo-Top system, the light source is located above the tape, so that the influence of dripping liquids and dust is greatly reduced.

The NIGDuo-Back system is used where space is at a premium and the highest precision is required. The light source is located below the strip.

Your advantage:

  • Low space requirement
  • Both the sensor housing and the light source are located above the strip
  • Simple calibration
  • Precise, fast measurement

Two CMOS area scan cameras, NIGeye, which are aligned at a defined angle to each other, are located in a stainless steel housing. A controller board is also integrated. The sensor is designed to operate without any additional external electronics. For edge position measurements, one sensor head is used, for strip position measurements two sensor heads, one of which serves as master.

NIGDuo-Top

In addition, an LED incident light is required above the strip, the light is projected onto the strip in the entire field of view of the cameras.

NIGDuo-Back

The LED light source is located below the strip.

Technical data

Dimensions (per housing) 600 mm × 380 mm × 210 mm (W × H × D)
Gewicht (je Gehäuse) 20 kg
Schutzklasse IP 65
Measurement uncertainty
Edge position measurement, 2σ
Strip centre pos. measurement 2σ
on request
on request
Max. vertical strip fluctuation
Up to ±100 mm
Power supply
24V DC (±10 %)